Drafe Beer System, Prob....

Message

N1000 · #1 Post by **N1000** » Thu Jul 20, 2006 1:41 am

I'm still working on my kegerator project and have run into yet another snag. I have a dual gauge co2 regulator and atm only have one keg. I assumed there was some sort of shut off valve for the co2 side that is not being used. Turns out there is not. Is there a way for me to run one keg on a dual gauge co2>>>>>Thanks for the help in advance! N1000

sundy58 · #2 Post by **sundy58** » Thu Jul 20, 2006 6:59 am

No sure what the setup is but how about a brass plug from the hardware store? Use some type of thread sealer.

Greenblood · #3 Post by **Greenblood** » Thu Jul 20, 2006 8:21 am

As Dennis said, it would help to know what kind of fittings you have on the reg, but assuming you have MPT/MFL ball check fittings, there are check valve caps.
http://www.northernbrewer.com/gas-handling.html

You can probably get something similar at the hardware store. You can also look into replacing your valves with a shut off valve.

Cheers!

John