Lawrence Brewers Guild

I'm thinking about adding a 2nd tap to my kegerator. Northern Brewer has a stainless steel barb tee, K220, that fits 3/16" to 1/4" I.D. tubing; but they are out of stock.

Micromatic has 3/16" and 1/4" stainless steel tees, but the 1/4" is twice the cost of the 3/16"
http://www.micromatic.com/draft-keg-bee ... d-380.html

I use 1/4" I.D. for gas line, 3/16" I.D. for beer line.

If the NB says it covers 3/16" to 1/4", are they being too general or does it not really matter that much as long as you clamp it down tight enough? I use screw clamps because I haven't hand a reason to switch to Oetiker (sp?). If it isn't that big of a deal, I was leaning towards placing my order with micromatic because the shank, nuts, tees, shipping are all in stock and a tad less than NB.

Thoughts?

I, personally, wouldn't put a 3/16 line on a 1/4 tee. You might consider trying it but don't do it without several zip ties or at least two clamps. It's not really designed for that and I would be worried about light to heavy leaking.

I found some proper sized tees pretty cheap on eBay.

Although, I gotta be honest, just reading the topic I thought you were interested in identifying a yeast cell count from its optical density.

Not quite what you had in mind.