Page 1 of 1
Drafe Beer System, Prob....
Posted: Thu Jul 20, 2006 1:41 am
by N1000
I'm still working on my kegerator project and have run into yet another snag. I have a dual gauge co2 regulator and atm only have one keg. I assumed there was some sort of shut off valve for the co2 side that is not being used. Turns out there is not. Is there a way for me to run one keg on a dual gauge co2>>>>>Thanks for the help in advance! N1000
plug
Posted: Thu Jul 20, 2006 6:59 am
by sundy58
No sure what the setup is but how about a brass plug from the hardware store? Use some type of thread sealer.
Posted: Thu Jul 20, 2006 8:21 am
by Greenblood
As Dennis said, it would help to know what kind of fittings you have on the reg, but assuming you have MPT/MFL ball check fittings, there are check valve caps.
http://www.northernbrewer.com/gas-handling.html
You can probably get something similar at the hardware store. You can also look into replacing your valves with a shut off valve.
Cheers!
John